Hardware Setup

Step 1

Place the Omni 20’s into the open bays with the AC side facing upwards.

Step 2

Press the power button on each Omni 20.

Step 3

Plug the AC power cable into the base of the Power Station and connect the other end to the wall socket.

If the station is powered on, each power bank LCD screen will display a battery icon. If the battery icon does not appear, try pulling the charger out of the bay, placing it back into it, and making sure it is fully seated. If the problem persists, contact support at powerstation@omnicharge.co.

WiFi Setup


Step 1 Plug the station into an ethernet port that will provide a DHCP lease and access to the internet.	Step 2 Power on the station.	Step 3 Log into the SmartCenter with credentials provided by the customer success team and confirm that the station is listed as online.

Step 4 Click the configure button next to the station (not shown if the station is offline)	Step 5 Log into the WiFi configuration page and setup your WiFi.	Step 6 Unplug the ethernet and deploy the station.